What could cause the QT200 to not be taking in air stronly?
Ducts, exhaust vent look good, unit running, but I'm having issues with water condensing in bathroom after shower. Tissue held to vent has to be single ply and held flat against the vent for the until to keep tissue up. I have lower CFM fans in house that easily hold up a 3 ply tissue. Ideas?
I have the same problem and have no answer .I would think that Nutone would have responded to these reviews with all the answesr Sorry
Date published: 2017-05-27
Are the QT series fans available in lower CFM?
I have a bath room with an existing fan that needs to be replaced. the Bathroom is 7'hx 7'W x 8"H. I do not need this fan at 200CFM. I only need a fan around 110CFM max. The existing duct work is 10" x 3.25" duct. The duct will have to cross over a 2"x6" rafter to connect to the existing duct. This fan allows me to clear the existing rafter but the CFM's are 3 to 4 times than I need.
Thank you for your question on the bath and ventilation fans. We have numerous Quiet Test fans that are rated at 110 CFM. Depending on the unit, these will use either four or six inch duct work. Please contact the Technical Service Department at 888-336-6151 for assistance.
Date published: 2014-02-17
replace only the heater?
The fan in the bathroom has been there 11 years. Can only the heater portion be replaced or is it better to replace the entire unit.
Thank you for your question on bathroom exhaust fan/heaters. The repair parts available would depend on the model number of the unit. Please contact the Technical Service Department at 888-336-6151 for assistance.
Date published: 2015-03-26
Can the QT200 be installed in a bathroom that has a shower and tub if it is installed so that it is not directly above either the shower or the tub? And if so, what sort of horizontal separation would be appropriate ... is 1 or 2 feet horizontal away from the shower/tub enough?
Thank you for your question on the model QT200 exhaust fan. The QT200 can be installed in a bathroom as long as it is not installed over the tub or shower. As far as we are concerned, it just needs to be outside the tub or shower footprint, but you may want to check with your local building codes for other restrictions in your area.
Date published: 2014-12-08
can insulation be touching the unit?
Thank you for your question on the model QT200 exhaust fan. The QT200 is IC rated and you can place insulation against the sides and on top of the unit housing up to an R40 value.
Date published: 2014-10-07