Is it possible to add a duct to this hood?
I currently have this hood, but it recirculates smoke and causes my smoke detector to go off. Is it possible to create a hole to convert this into a duct hood?
Yes, I just purchased it. I don't have duct work, but on the box, it said it could be vented or non-vented.
Date published: 2013-11-23
Can it be mounted rotated 90 degrees?
I have a sloped ceiling where the 24" wide stove is. Cutting a new cabinet at that slope may not be practical. Is it possible to rotate the hood so that it faces to the right of the stove instead of the front, or would that cause problems with performance? Might it also cause problems with bumping into it if mounted 24" above the stove to the bottom of the hood? I read I can mount as low as 18" above the top of the stove burners?
Thank you for your question. The RL6200 Series must be mounted beneath a cabinet. You cannot rotate the hood 90 degrees because it will not operate properly. The range hood must be mounted between 18-24 inches above the cook top.
Date published: 2017-12-27
where is the electrical knock out, access hole located.
I would like to prep the electrical for one of these units, and need dimensions so that my electrical cable is coming out of the wall where the KO is going to be located.
Thank you for your question. There are (2) electrical knockouts on this range hood. They are both located on the right hand side when looking at the hood. One is on top and the other is on the rear of the hood. Both are approximately 7 ½ inches from the right side. I hope this is helpful.
Date published: 2013-10-23