Locate Model Numbers

IMPORTANT:
About NuTone Model Numbers

Some NuTone model numbers have an alpha suffix.

Example: 41000-L.

It is important to refer to the exact model number with the alpha suffix when selecting parts, requesting service or speaking to a technical support representative regarding your NuTone product.

Standard Under Cabinet

Label Placement

The model label is located either on the right or left side wall of the range hood canopy.



Allure Under Cabinet

Label Placement

Remove range hood filters by pulling down on the filter tabs. The series number is located either on the back wall of the range hood housing or on the Teflon air pan.
(Example...QS1, QS2 or QS3)




Island Downdraft

Label Placement

The model label is located on the front of unit beneath the cook top.
Cabinet drawers or shelving may need to be removed to access label.



Standard Bath Fan

Label Placement

Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located in the corner closest to the outlet. Some fans may have the model stamped into the motor plate instead or a printed sticker label.



Whole House Ventilator

Label Placement

The data label is located on top corner of the unit housing.



QuietTest

Label Placement

Remove the grille by pulling down 2 inches. Reach between the grille and ceiling and squeeze the mounting springs together. Pull springs out of slots in mounting plate. The model label is located on the power unit mounting plate..



Powerd Attic Ventilators (PAVs)

Label Placement

The model label is located on the cover of the wiring box which is visible from the attic.



Utility Ventilators

Label Placement

Remove the grille by a central knob or two screws. The model may be ceiling or wall mounted. The label is located on the inside perimeter of housing opposite wiring panel.



Central Vacuum - Power Head

Label Placement

The model number is located on the bottom of the power head.



Central Vacuum - Power Units

Label Placement

The model label is located on the side of the power unit.



Bulb Heater

Label Placement

Remove the bulb(s) from the unit. Remove the springs from the hooks inside the rough-in box. The model number is located on the inside end of the rough-in box.



ValueTest Heater

Label Placement

Release the locking tabs on the lens. Remove the lens. Remove the reflector mounting screw. Remove the reflector and grille. The model number is located on the inside edge of the housing.